Hello and welcome to this lecture in this lecture we configure IP addressing on the windows machine
so that we are able to access both of the 48 firewalls through a GDP.
So as you know we have two interfaces zero by zero and one by zero as it is outlined by the.
By the genius tree.
So I will go now into the network settings and set this IP so 172 sixteen one hundred that one hundred
on the first the first niqab and 172 that.
That 200 that 100 again on the second niqab.
So let's go now and say this.
OK.
Right click and open network ensuring center change Adapter Settings.
And we have two new cards available.
The third one it's desirable because as you can see here we haven't done any configuration on this is
crazy and management zero by zero.
It's in the shutdown state.
So it's not enabled.
So that's why the third night card shows as visible now for the first one right click and go to properties
nothing nothing special.
And let's say here that we have 172 that 16 that 100 are 100 I think.
So let's make sure 100 that 100.
It's a slash 24.
And let's go and see slash 24.
We don't need any default gateway and just apply the configuration.
Now let's do the same for the second interface and properties.
Let's go on to the DPP before properties 172 16.
Two hundred that one hundred slash 24 and click OK hopefully it's fine now.
So let's let's do some testing command prompt and yes enter.
Now I will say IP config So IP config.
And let's test the first one.
If we look on the diagram we should bring 172 16 one hundred that one.
So let's do that.
What I believe I haven't enable ICMP here.
So let me just check.
So I mean and let's say show system interface port three.
And yes.
So it's not enabled.
Which means that it will not answer to two ICMP.
So config system interface and edit for three and append which means I would add another service to
this to his list of banned.
Allow access and let's say Bing.
And now if I run the command again and say show system interface port three I have ping 80 percent GDP
let me just do the same for the branch 48 so that we're able to test connectivity from the windows machine
to to both of the firewalls.
So configure system interface at the port three append allow access ping
show system interface just hit enter for poor three now we have also been HDP us and HDP which is perfect
ok so getting back to the Windows machine
lets being now so paying 172 that sixteen that one hundred that one.
And we have connectivity and let's being also 201 which means the branch 48.
Perfect let's try.
Now 172 that's sixteen.
That one hundred that one.
And here it is with add me no password just enter I will change password now I will just click on later
and I want to see exactly how it how it looks.
Perfect.
We can reach the interface of the HQ 40 gauge firewall.
Let's try for the second one as well.
172 that sixteen.
That two hundred and one.
And here it is.
So it's reachable.
Perfect.
We can connect with admin enter and I will change the password later remind me later and we can see
that the user interface the graphical user interface it's both for both of them it's available.
So this is everything we have to do in this lecture.
So now we can reach both of the 48 firewalls from the windows machine so we can start running the IP
VPN wizards.
So thanks a lot and see you in the next lecture.