 USER'S GUIDE


 Running the program
1. Boot from a clean DOS disk.
2. Change to the drive/directory where FJERASE.EXE is located.
3. At the DOS prompt, type FJERASE to execute the program.


4. Inside the program
	At the startup routine, the program tries to identify all IDE drives
	connected in your system (Primary and Secondary Port). This procees
	may take some time.
	Afterwhich, all the drives found will be displayed in the Main Menu 
	window with the corresponding valid product ID. Port with no drive(s) 
	connected will also be displayed with 'NONE' as its product ID.
	Hotkeys are indicated in the taskbar. Use the up and down arrow keys 
	to move the current highlighted drive.
	    Hotkeys Definition:
	    F1 - Displays the Help Window
	    F4 - Reinitializes the whole hard disk user area to '00' data 
                 pattern effectively erasing all its previous contents.
	         
		 **  Once this task is started, and even if you abort the 
		     procedure, your hard disk data may already be lost and
		     irretrievable. Please remember that MBR, Partition 
		     Tables and FAT are located in the first few cylinders 
		     of your hard disk and this ERASE functions starts writing
		     from this area of your hard disk. 
		 **  The completion time for this task depends on the capacity
		     of your drive and the clock speed of your host processor.
		     (e.g. For a Pentium 133Mhz processor, it takes 
		     approximately 10 minutes to erase the whole drive with
                     1 GB capacity.
		     This completion time doubles as your CPU clock speed
		     reduces to half. --- 66Mhz -> 20 minutes for 1Gb cap.)

		 ------------------------------------------------------------
		  		      WARNING!!!
		 ALL DATA ON THE DRIVE WILL BE LOST. PLEASE BACKUP ALL YOUR 
		 IMPORTANT DATA BEFORE PERFORMING THIS TASK.
		 ------------------------------------------------------------
		 
	    Enter - Displays basic information about the drive
	    Esc - Prompts to quit the program.